Mr. Steam MSITPLUSSQ-ORB Guia de Instalação descarregar pdf (Página 10)

Installing the Remote

Temperature Probe

(PN: MSTS)

The Remote Temperature Probe is required

when the iTempo or Tempo/Plus Controls

are installed outside the steam room.

The Remote Temperature

Probe (P/N MSTS) is for use with iTempo

and iTempo/Plus Controls only. Do not use

with any other controls. Do not use any

other temperature probe with the iTempo

and iTempo/Plus controls. Noncompatible

products may result in an inoperative con-

trol and a hazardous condition.

Install the iTempo or

iTempo/Plus controls according to the in-

stallation instructions on pages 3-5. Failure

to do so may result in an inoperative con-

trol and a hazardous condition.

1. Determine the location of the Remote

Temperature Probe:

The Remote Temperature Probe must be

installed

a. On a vertical surface

b. 4-5 feet above the floor

c. in a location representative of the desired

steam bathing temperature. Locating the MSTS

near the steamhead or near direct steam emis-

sions may result in poor steamroom temperature

control.

d. The probe has an integral 30' cable. Insure that

the probe and/or steam generator are located ac-

cordingly.

2. Drill a 5/16 inch diameter hole in the wall. Do

not oversize or undersize the hole. Clean area

thoroughly.

NOTE: The silicone supplied by Mr. Steam can be

used to meet a variety of sealing and gasketing. It

cures to silicone rubber and adheres to glass,

wood, metal, porcelain, ceramic tile, painted sur-

faces, many plastics and rubber. Surfaces must be

clean and dry. Apply thin layer of product. Fit to-

gether and support if necessary. Allow excess mate-

rial to cure, then trim with a sharp blade. Sealant

“skins” in 5 minutes, dries to touch in 1 hour. Fully

cures and bonds in 24 hrs.

3. Remove the knock-out from the steam

generator jacket as shown in Diagram 1.

Insert the probe cable through the knock-out and

connect to the connector on the steam generator

printed circuit board marked EXT TEMP as shown in

Diagram 1.

CAUTION

steam

Installation & Operating Instructions

______________________________________________________________

64602_Brochure_PUR100474_Layout113-02-1116:02Page10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comentários a estes Manuais

Sem comentários

Mr. Steam MSITPLUSSQ-ORB Guia de Instalação Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Geradores de energia Mr. Steam MSITPLUSSQ-ORB