Mr. Steam S3C1IAFWH Guia de Instalação descarregar pdf (Página 29)

steam

Controls

__________________________________________________________________

Locating the Control

Determine the desired installation location of the control. The iSteam 2.0

controls are designed to be installed inside or outside the steam room

as a matter of personal preference. If the control is installed inside

the steam room:

• Locate the control 4-5 feet above the oor near the bather seating area.

• The control features an integral temperature sensor. Locate the control in a

location representative of the desired steam bathing temperatures. Do not

locate the control above or near the steam head or direct steam emissions.

• Locate the control on a vertical wall.

• The control and AudioWizard

™

cables are 30 feet. Insure that the control,

steam generator and optional AudioWizard are located accordingly.

IMPORTANT NOTES:

• If required, contact Mr.Steam to purchase an optional 60’ iSteam 2.0

control cable part number 104117-60.

• A 60 foot cable is NOT available for AudioWizard.

• If the control is installed outside the steam room a Remote Temperature

Probe Part Number iMSTS must be installed inside the steam room.

Refer to the iMSTS installation manual before installing the control.

• Insure Mr.Steam steam generator is iSteam 2.0 compatible and has

a serial number 930030 or higher.

Installation with Optional Rough-In Box

A rough-in box is supplied with iSteam 2.0 for new construction.

The rough-in box will allow precise location of the iSteam 2.0 control and

provide a secure and easily identiﬁable place for the cables while the steam

room is being constructed.

STEP 1

Take the rough-in box out of the package. Remove the two screws (1a )

and place them in the top and bottom wings of the rough-in box (1b).

STEP 2

Select a KNOCK-OUT (2a) to route the control cable into the box.

Use a second KNOCK-OUT if the optional AudioWizard is used.

STEP 3

Line up the two TABS (3a) on the right of the box against a stud.

These TABS help locate the box to sit PROUD of the stud (3b).

STEP 4

SCREW (4a) the two supplied screws into the stud.

STEP 5

Route the CONTROL CABLE (5a) through the back of the rough-in box

and clip it under one of the TABS (5b) that previously held the screws.

The two ends of the control cable are the same.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

Comentários a estes Manuais

Sem comentários

Mr. Steam S3C1IAFWH Guia de Instalação Página 29

Comentários a estes Manuais

Manuais e produtos relacionados com Geradores de energia Mr. Steam S3C1IAFWH